Complete set of quick-release LED turn signals for the front and rear, for enduro, off-road or track riding: before a technical section, remove them with one click in just a few seconds and without tools, then put them back on to return to the road legally. Branches, falls and transport on a trailer will no longer break them.

Will it fit my motorcycle?

The mounting is universal. The socket fits into a 10 mm hole in a number plate holder, number plate bracket or mounting bracket, with enough plastic or metal around it for the fastening nut (23 mm in diameter). It therefore fits almost all enduro, dual-sport and adventure motorcycles: KTM, Husqvarna, GasGas, Yamaha, Honda, Kawasaki, Suzuki, SWM and others.

If your motorcycle was originally equipped with bulb turn signals, you will also need LED turn signal resistors, sold separately: without them, the turn signals will flash too quickly or will not flash.

What you receive

• 2 left and 2 right quick-release turn signals
• 4 sockets to mount on the motorcycle, with wiring and a rubber cover to protect against water and mud
• 1 mm and 2 mm nylon spacers for adjusting the thickness

Features

• Line: Prima
• Colour: black
• Light: high-intensity SMD LED, 3D optical lens with glossy and satin surfaces
• Body: injection-moulded plastic
• Mount: universal M10 with anti-rotation nut, 10 mm hole
• Approval: E-mark, UNECE Regulation 50, No. 50R-0313
• Manufacturer's warranty: 2 years

How to install them

1. Disconnect the battery and remove the original turn signals.
2. Insert the socket into the hole with the washer and spacers: the bottom of the nut notch must remain flush with the thread. If too little thread protrudes, thin the plastic from the inside.
3. Position the notch horizontally, engage the turn signal to align everything and tighten by hand from behind, using a drop of medium-strength threadlocker.
4. Connect the red wire to positive and the black wire to ground. If the turn signal does not light up, reverse the two wires: LEDs are polarity-sensitive.

We recommend having them installed by a workshop.

Use and maintenance

Clean the turn signal before engaging it. When you remove it and when you wash the motorcycle, close the socket with the dust cap.